Ward door

French doors: standard dimensions of 1500*2100mm, fitting for surgery room entrances, emergency exits, and corridor doors, facilitating easy passage for gurneys and supply carts.

Classification：

Ward Door

keywords：

Ward door

8613335219899

xiuqiangindustry@gmail.com

Inquiry

Contact

Ward door

Standard sizes for ward doors in different areas

1. Single door: standard size ranges from 700-1000*2100mm, suitable for ward entrances, imparting a sense of security and comfort to patients.

2. Double-leaf door: Comprising one larger and one smaller door leaf, typically sized at 1200*2100mm, ideal for hospital conference rooms, laboratories, and testing departments, conveying a spacious and majestic atmosphere.

3. French doors: standard dimensions of 1500*2100mm, fitting for surgery room entrances, emergency exits, and corridor doors, facilitating easy passage for gurneys and supply carts.

4. Bathroom door for wards: standard size of 600*2100, usually compact to accommodate basic access without requiring excessive space.

As the "face" of the hospital, the quality and safety of medical ward doors are of utmost importance. Therefore, meticulous attention must be paid during installation to avoid any defects due to oversight or other reasons. Here are ten common mistakes to avoid during installation:

1. Transportation: Take precautions to prevent scratches or dents on door frames and leaves during transportation. Ensure they are placed on a level, indoor surface away from direct sunlight yet with good air circulation.

2. Installation timing: Ward door installation should only proceed after completion of flooring works (like tiles or stone installation) and wall plastering and leveling. In areas destined for tile or stone cladding around the doorway, ensure the surfaces are fully aligned with the edges of the opening.

3. Installation method: Adopt the pre-cut opening installation method strictly; avoid concurrent installation with masonry work around the opening.

4. The ward door installation need to check the hole wall humidity, if the installation of the hole wall humidity <25%, it is normal to continue to install; if the installation of the hole wall humidity > 25%, it should be installed on the wall to do a good job on the moisture-proof isolation layer.

5. If it is a corner wall or wall installation ward door, in the installation before the need for the side without the door stack to do a face width size of not less than 50mm “false wall”. Of course, the width of the false wall can be determined according to the width of the line, to avoid the two sides of the face to show the door edge line asymmetry. Door vision, your friend!

6. If the door frame is made of MDF material, then in the spelling door frame need to use screws to spell frame; if the door frame is made of multi-layer board or solid wood board, then in the spelling of the door frame can be used to fix the iron nails.

7. The installation of wards door frame must be adjusted to the verticality of the door frame, to avoid playing on the foam, because of the role of the foam drying and expansion and damage to the door frame.

8. Because the door frame on both sides of the line may be energized, so in the installation of the door frame, electricity operation needs to be standardized.

9. The measurement of gross opening according to the decorative baseline to confirm the ground molding height and wall thickness.

10. Single sliding door, mother and son door, double door opening door hole reserved size (set of plate thickness of 32mm): door opening height = door height +40mm, door opening width = door width +65mm.

Other types of combination of doors according to the specific circumstances (Note: the height of the doorway refers to the net height of the ground works from the hole has been made, the width of the doorway, the thickness is also the net size).

Ward door

Medical airtight door